The Winterwarm JET-S is sustainable air heating for high areas
- Applicable in high areas with 5 to 15m height
- Sustainable heating solution
- Simple control 0-10V or on/off signal
- Conical nozzles with induction of air
- Energy saving heating solution
Description
Sustainable heating of high areas a challenge? Not with the Winterwarm JET!
With the special nozzles this air heater distributes the warm air from underneath above downward. This way the JET prevents warm air from assembling underneath the ceiling. Energy is saved and comfort enhanced because the temperature difference between ceiling and floor remains limited.
The JET-S is the standard model which can be controlled by means of a simple 0-10V controller or any other on/off signal.
In situations without destratification, the temperature typically increases by 1.3°C per meter of height. When installing a JET this temperature difference is only about 0.16°C per meter, thus limiting the heat loss through the roof. On top the inducing nozzles take care of an optimal distribution of the heat.
The Winterwarm JET can be connected to each heat pump, boiler of district heating system and is provided with a coil which is especially designed to realise as high as possible heat output at low water temperatures.
The heaters are provided with economical EC fan motors of which the speed can be adjusted continuously (0-10V) for more comfort.
There are no destratification fans needed anymore which reduces the electricity consumption even further.
Features
- Applicable in high areas with 5 to 15m height
- Comfortable heating solution
- No extra recirculation fans needed
- Conical nozzles with induction of air for more air recirculation
- Up to 30% energy savings
- CO2 reduction as a result of lower energy consumption
- Control by means of a 0-10V speed controller of any other on/off signal
- Low sound level
- Low investment costs